H06.25 Software Installation and Upgrade Guide

9 Loading This RVU
This chapter describes how to perform a system load of this RVU into the memory of each processor
in a NonStop system.
NOTE: For detailed information on performing a system load, see in the NonStop Operations
Guide.
By default, one $SYSTEM is already configured. You can select $SYSTEM, FCDM-Load,
CLIM-Attached-Load for systems that support this type of load), or an alternate system volume:
The $SYSTEM disks must contain the current RVU operating system files for the NonStop system.
Table 16 and Table 17 identifies the possible load paths to use for an FCDM-Load and a
CLIM-Attached-Load, respectively:
Table 16 System Load Paths in Order of Use for FCDM-Load
Over ServerNet FabricTo ProcessorData Travels FromDescriptionLoad Path
X0$SYSTEM-PPrimary1
Y0$SYSTEM-PPrimary2
X0$SYSTEM-BBackup3
Y0$SYSTEM-BBackup4
X0$SYSTEM-MMirror5
Y0$SYSTEM-MMirror6
X0$SYSTEM-MBMirror backup7
Y0$SYSTEM-MBMirror backup8
X1$SYSTEM-PPrimary9
Y1$SYSTEM-PPrimary10
X1$SYSTEM-BBackup11
Y1$SYSTEM-BBackup12
X1$SYSTEM-MMirror13
Y1$SYSTEM-MMirror14
X1$SYSTEM-MBMirror backup15
Y1$SYSTEM-MBMirror backup16
Table 17 System Load Paths in Order of Use for CLIM-Attached-Load
Over ServerNet FabricTo ProcessorData Travels FromDescriptionLoad Path
X0$SYSTEM-PPrimary1
Y0$SYSTEM-PPrimary2
Y0$SYSTEM-BBackup3
X0$SYSTEM-BBackup4
X0$SYSTEM-MMirror5
Y0$SYSTEM-MMirror6
Y0$SYSTEM-MBMirror backup7
X0$SYSTEM-MBMirror backup8
111