H06.25 Software Installation and Upgrade Guide

Configured Location........ Group 100 , Module 2 , Slot 5 , Port 1
ConnPts.................... 2
X1 Location................ Group 100 , Module 2 , Slot 5 , Port 1
Y1 Location................ Group 100 , Module 3 , Slot 5 , Port 1
SvNet ID 1................. 0x000E0DC6
X2 Location................ Group 100 , Module 2 , Slot 5 , Port 2
Y2 Location................ Group 100 , Module 3 , Slot 5 , Port 2
SvNet ID 2................. 0x000E0EC6
Maintenance Interface IP... 16.107.184.198
Network CLIM Information:
MultiProv.................. ON
Provider................... CSAM2
Index...................... 1
The NonStop host system name in this example is \NSAA11 and the maintenance interface
IP address is 16.107.184.198.
b. Use the climcmd clim-name climconfig interface -info eth0 command
from a TACL prompt for the CLIMs to obtain the netmask and gateway. For example:
20> climcmd c100251 climconfig interface -info eth0
comForte SSH client version T9999H06_17May2009_comForte_SSH_0086
Interface : eth0
Interface Type : Physical Interface
Jumbo Frame : NO
IP Address : 16.107.184.198
Netmask : 255.255.255.0
ROUTE Details :
- Route Type : Default Route
Destination Address : 0.0.0.0
Netmask : 0.0.0.0
Gateway Address : 16.107.184.1
Metric : 0
Minimum RTO : Unspecified
Auto Negotiation Details :
- Status : on
Line Speed : Not Applicable
Duplex : Not Applicable
Software MAC Address : Unspecified
Termination Info: 0
In this example, the netmask is 255.255.255.0 and there is no gateway configured.
c. Use OSM Low-Level Link to connect to the CLIM and obtain PCI Slot configuration
information.
d. Make note of all values.
If Falling Back to the H06.15 RVU or an Earlier RVU
Modify OSSINFIL
If you are falling back to an H06.15 or earlier H-series RVU, before halting the processors, you
must restore the SERVER #ZPLS entry in the OSS subsystem maintenance file OSSINFIL on all systems
with OSS installed. If you commented out this entry when installing this RVU, use TEDIT to modify
the entry as follows:
TEDIT $SYSTEM.ZOSSINS.OSSINFIL
Then change
* SERVER #ZPLS
to
SERVER #ZPLS
This change is required for correct startup of OSS.
Before Halting the Processors 141