H06.25 Software Installation and Upgrade Guide

In the Halted State, Prepare the CLIMs
1. For each CLIM, set the IP address of eth0 via the iLO serial console.
a. At the Linux prompt, log onto the CLIM. CLIMs are shipped with two default maintenance
interface usernames and passwords:
• root/hpnonstop
• user/clim
b. At the Linux prompt, add the interface by entering this command:
climconfig interface –add eth0
c. Add the IP address and bring up the eth0 interface by entering:
climconfig ip –add eth0 –ipaddress ip-address -netmask netmask
2. Reboot the CLIMs by entering:
reboot
3. Use OSM Low-Level Link to perform the Configure action on each CLIM. In the Configure CLIM
dialog box, enter all the information that you gathered before starting this procedure. For
example:
Be sure to select the CLIM type for the type of CLIM you are configuring from the Mode of
operation pull-down menu. After entering the required information in the dialog box, press
Configure. Here is an example screen showing the CLIM preparation has successfully
completed:
While the Processors are Halted 143