H06.25 Software Installation and Upgrade Guide

CLIM NAMEAdding a server to a VM cluster server group without an
available connection (“sharer”) prevents connection to storage
is the name of the CLIM to be used.
IP
is the IP address of the CLIM to be used.
*
runs SSOCLIM on all available CLIMs.
CLIM USER
is the user name to be used against a CLIM when CLIM NAME or IP is used or against all
available CLIMs when * is used.
PASSWORD
is the password to be used against a CLIM when CLIM NAME or IP is used or against all
available CLIMs when * is used.
FORCED
, if specified, suppresses the warning instruction to run SSOCLIM on all the CLIMs.
Complete CLIM Setup
1. Establish trust between the CLIM and the NonStop host system.
If you are falling back to H06.20 (or to an RVU with T0682H02^ACC) or H06.21 (or to an
RVU with T0682H02^ACI), you must run SSOCLIM as SUPER.SUPER. If you are running or
falling back to H06.22 or a later RVU, you can run SSOCLIM as any SUPER group user. In
all cases, you must run SSOCLIM twice, once with the root username and hpnonstop
password, and once with the user username and clim password. .
a. At a TACL prompt, log on as SUPER.SUPER (for a fallback to H06.20 or H06.21 or as
any SUPER group user.
b. Enter SSOCLIM.
The script prompts you for the CLIM name or IP address of the CLIM. Enter that parameter.
Then the script prompts you for the username and password. Use the root username
and hpnonstop password.
c. Re-enter the SSOCLIM command using the user username and clim password.
2. Use CLIMRSTR to restore all the CLIMs with the CLIM backup files from the previous CLIM
version. Restore the files that you stored when you followed the CLIM software upgrade
procedures in “Back Up CLIM Configuration Files” (page 66).
NOTE: The CLIM configuration files used during this procedure must be of the same RVU as
the RVU to which you are falling back.
For the H06.16 RVU, rename and restore the backup files. For example, at the TACL prompt,
enter:
a. >FUP RENAME $DATA1.BCKH0616.N100251, $DATA1.BCKH0616.BACKUPGZ
b. >CLIMRSTR N100251 $DATA1.BCKH0616
c. Repeat steps a. and b. for each CLIM.
For H06.17 and later RVUs, restore the backup files. For example, at the TACL prompt, enter:
a. >CLIMRSTR N100251 $SYSTEM.N10251.BCKH0617
b. Repeat for each CLIM.
3. Reboot the CLIMs:
a. For large systems, boot one of every pair of CLIMs on the system at the same time.
After Loading the Previous RVU 147