H06.25 Software Installation and Upgrade Guide

Table 9 Upgrade Checklist (continued)
Done?ReferenceTask Description
“Verify System Processes” (page 68)8. Verify system operations.
Cluster I/O Protocols (CIP) Configuration and
Management Manual (installation procedures), CLuster
9. Install CLIM software on the
NonStop System Console.
I/O Module (CLIM) Software Compatibility Reference
(CLIM software and firmware compatibility information)
“Receive New Software Into the Archive” (page 79)10. For those with NonStop Software
Essentials, receive the RVU SUT into
DSM/SCM software archive
“Receive New Software Into the Archive” (page 91)11. For those with DSM/SCM Planner
Interface, receive this RVU SUT into
DSM/SCM software archive.
“Create a New Software Revision” (page 81)12. For those with NonStop Software
Essentials, create this RVU software
configuration revision.
“Create a New Software Revision” (page 95)13. For those with DSM/SCM Planner
Interface, create this RVU software
configuration revision.
“Build and Apply the New Software Revision” (page 84)14. For those with NonStop Software
Essentials, build and apply this RVU
software revision.
“Build and Apply the New Software Revision” (page 98)15. For those with DSM/SCM Planner
Interface, build and apply this RVU
software revision.
“Print Operator Instructions From the Target Interface
(ZPHITI)” (page 102)
16. Print DSM/SCM Operator
Instructions.
17. Prepare for Down System CLIM
Firmware Update action on the OSM
Service Connection.
• “Managing CLIM Firmware” (page 34)
• OSM Service Connection online help
Chapter 8: “Running ZPHIRNM ”18. Run ZPHIRNM.
“2. Halt the Processors” (page 114)19. Halt the processors.
“3. Power Cycle the Processors if Necessary” (page 114)20. If you are upgrading from H06.03
or H06.04, power cycle the
processors.
“4. (Required for Upgrade to H06.25 or Later) Perform
a Hard Reset” (page 114)
21. If you are migrating to H06.25 or
a later RVY, perform a hard reset of
the processors.
“5. (Optional) Upgrade the CLIM Software” (page 115)22. Update CLIM software on all
CLIMs by performing a CLIM software Cluster I/O Protocols (CIP) Configuration and
Management Manualupgrade using the OSM Low-Level
Link. (If you are migrating from
H06.17 or a later RVU and performed
an online upgrade of the CLIM to the
CLIM software released with this RVU
before starting the host system
upgrade, you can skip this step.)
“Managing CLIM Firmware” (page 34)23. Update firmware for CLIM
components as needed.
“6. Loading the System” (page 115)24. Load system with this new RVU.
“Managing Maintenance Entity (ME) Firmware and ME
FPGA Firmware” (page 24) and the CSSI web page
25. Update ME and ME FPGA
firmware, if necessary.
64 Upgrade Checklist