H06.27 Software Installation and Upgrade Guide

8. (Optional) Confirm that the Spooler is active and not 100 percent full before executing the
Build/Apply request. At a TACL prompt, start SPOOLCOM and issue a COLLECT, STATUS
command. For example:
12> spoolcom $spls; collect, status
COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL
$S ACTIVE 3 , 1 154 4 $OPS0.SPL.DATA 4
9. In the Build/Apply Request dialog box, click OK.
104 Installing a SUT for This RVU Using the Planner Interface