H06.27 Software Installation and Upgrade Guide

SPOOLCOM> SPOOLER, DRAIN
This command causes the Spooler to move from the active to the dormant state.
CAUTION: Do not use the TACL STOP command to drain or stop the Spooler. Also, do not
issue the TACL STOP command after you have issued the SPOOLCOM DRAIN command. The
control file can be corrupted during the next warmstart or rebuild.
For more information on draining the Spooler and recovery, see Chapter 1 in the Spooler
Utilities Reference Manual.
Run ZPHIRNM
Using PREVIEW Mode
You can do a preview run of ZPHIRNM to check that the target subvolumes (TSVs) and associated
map files are consistent. Running ZPHIRNM in PREVIEW mode simulates the ZPHIRNM process
without actually updating files or activating the configuration. In PREVIEW mode, ZPHIRNM indicates
whether or not TMF needs to be up when running ZPHIRNM.
Run ZPHIRNM
1. At a TACL prompt, enter from the DSM/SCM subvolume:
> RUN ZPHIRNM $vol.SYSnn
where:
• $vol specifies the default current system load volume, usually $SYSTEM.
• SYSnn specifies the SYSnn subvolume named previously in the backout request.
For example:
> RUN ZPHIRNM $system.SYS00
2. When asked if you want to use a log file with the session, type Y and press Enter.
3. When prompted, type a file name for the log file, and press Enter.
4. ZPHIRNM issues this message and begins processing:
Log file, <filename>, was successfully created.
5. Verify That ZPHIRNM Ran Successfully
Run ZPHIRNM 139