H06.27 Software Installation and Upgrade Guide

TACL> RELOAD *, PRIME
2. To load an individual processor, enter:
TACL> RELOAD nn
where nn is the processor number of the processor you want to reload.
If the reload is initiated successfully, this message appears in a startup TACL window on the
system console screen:
PROCESSOR RELOAD: nn
After Loading the Previous RVU
After loading the previous RVU, perform these tasks.
If Falling Back to the H06.03 or H06.04 RVU
If you are falling back to the H06.03 or H06.04 RVU, then after loading the previous RVU, finish
loading the rest of the NonStop Blade Complex firmware, as described in step 6c under “Reverting
to H06.03 or H06.04 From This RVU” (page 155).
Using the SSOCLIM * Option to Run SSOCLIM on All Available CLIMs
For this RVU, SSOCLIM can be made to run on all available CLIMs by using the * option instead
of the CLIM IP or CLIM name in the SSOCLIM command line:
SSOCLIM [{CLIM NAME | IP | *}{CLIM USER} {PASSWORD}][FORCED]
Where:
CLIM NAMEAdding a server to a VM cluster server group without an
available connection (“sharer”) prevents connection to storage
is the name of the CLIM to be used.
IP
is the IP address of the CLIM to be used.
*
runs SSOCLIM on all available CLIMs.
CLIM USER
is the user name to be used against a CLIM when CLIM NAME or IP is used or against all
available CLIMs when * is used.
PASSWORD
is the password to be used against a CLIM when CLIM NAME or IP is used or against all
available CLIMs when * is used.
FORCED
, if specified, suppresses the warning instruction to run SSOCLIM on all the CLIMs.
Complete CLIM Setup
1. Establish trust between the CLIM and the NonStop host system.
If you are falling back to H06.20 (or to an RVU with T0682H02^ACC) or H06.21 (or to an
RVU with T0682H02^ACI), you must run SSOCLIM as SUPER.SUPER. If you are running or
falling back to H06.22 or a later RVU, you can run SSOCLIM as any SUPER group user. In
150 Falling Back on the CLIMs, Loading the Previous RVU, and Resuming Normal Operations