H06.27 Software Installation and Upgrade Guide

1. At a TACL prompt, enter this command from the DSM/SCM subvolume:
> RUN ZPHIRNM $vol.SYSnn
where:
• $vol specifies the default current system load volume, usually $SYSTEM.
• SYSnn specifies the current or new (depending on whether SYSGEN was required) SYSnn
subvolume.
For example:
> RUN ZPHIRNM $system.SYS00
2. When asked if you want to use a log file with the session, enter Y and press Enter.
3. When prompted, enter a file name for the log file.
ZPHIRNM issues this message and begins processing:
Log file is open, Zphirnm will now begin processing.
4. Verify that ZPHIRNM ran successfully by reviewing the log file.
5. If ZPHIRNM did not run successfully, correct the problem and rerun.
See the DSM/SCM User’s Guide for troubleshooting procedures and the DSM/SCM Messages
Manual for a complete list of ZPHIRNM messages.
If Running INSTALL^TEMPLATES Is Required
If the operator instructions state that you should run INSTALL^TEMPLATES to update EMS template
files, you must be logged on as the super ID (255,255) user to run the INSTALL^TEMPLATES macro.
This macro cannot be run with the NOWAIT option and takes approximately ten minutes to finish.
Since the G06.10 RVU, if there is a resident template file in any of the input subvolumes, the
INSTALL^TEMPLATES macro displays this error:
Invalid nonresident template file -- not key sequenced: $SYSTEM.ZTEMPL.NEWRES
*** INSTALL^TEMPLATES: Terminated due to error ***
HP recommends that you designate a unique subvolume to hold the template files created by
INSTALL^TEMPLATES. When you follow the suggested procedure, a nonresident template file is
not present in ZTEMPL, and the error does not occur.
1. Set the volume and subvolume to $SYSTEM.ZINSAIDS:
-> volume $system.zinsaids
2. Load the TACLMACS file:
-> load /keep 1/ TACLMACS
NOTE: If you run the INSTALL^TEMPLATES macro with no arguments, you are prompted to
provide required information. For information on the INSTALL^TEMPLATES arguments, print
the usage notes: -> volume $system.zinsaids -> load /keep 1/ TACLMACS ->
install^templates /out outdev/ help where outdev is the name of the desired
output device.
3. Choose a location on $SYSTEM to keep updated template files:
If Running INSTALL^TEMPLATES Is Required 161