H06.27 Software Installation and Upgrade Guide

Run ZPHIRNM
During the Build/Apply phase, DSM/SCM places product files in their subvolumes with temporary
(fabricated) file names so that the new files do not conflict with the file names of currently running
programs. After the Build/Apply finishes, run the ZPHIRNM program on the target system to:
• Rename the files that currently have actual file names with fabricated names. These files become
obsolete when the new files are renamed.
• Rename the new files, which have fabricated names, with their actual names.
1. At a TACL prompt, enter this command from the DSM/SCM subvolume:
> RUN ZPHIRNM $vol.SYSnn
where:
• $vol specifies the default current system load volume, usually $SYSTEM.
• SYSnn specifies the current or new (depending on whether SYSGEN was required) SYSnn
subvolume.
For example:
> RUN ZPHIRNM $system.SYS00
2. When asked if you want to use a log file with the session, enter Y and press Enter.
3. When prompted, enter a file name for the log file.
ZPHIRNM issues this message and begins processing:
Log file is open, Zphirnm will now begin processing.
4. Verify that ZPHIRNM ran successfully by reviewing the log file.
5. If ZPHIRNM did not run successfully, correct the problem and rerun.
See the DSM/SCM User’s Guide for troubleshooting procedures and the DSM/SCM Messages
Manual for a complete list of ZPHIRNM messages.
If Running INSTALL^TEMPLATES Is Required
If the operator instructions state that you should run INSTALL^TEMPLATES to update EMS template
files, you must be logged on as the super ID (255,255) user to run the INSTALL^TEMPLATES macro.
This macro cannot be run with the NOWAIT option and takes approximately ten minutes to finish.
Since the G06.10 RVU, if there is a resident template file in any of the input subvolumes, the
INSTALL^TEMPLATES macro displays this error:
Invalid nonresident template file -- not key sequenced: $SYSTEM.ZTEMPL.NEWRES
*** INSTALL^TEMPLATES: Terminated due to error ***
HP recommends that you designate a unique subvolume to hold the template files created by
INSTALL^TEMPLATES. When you follow the suggested procedure, a nonresident template file is
not present in ZTEMPL, and the error does not occur.
1. Set the volume and subvolume to $SYSTEM.ZINSAIDS:
-> volume $system.zinsaids
2. Load the TACLMACS file:
-> load /keep 1/ TACLMACS
168 Using DSM/SCM With the Planner Interface to Install SPRs