H06.27 Software Installation and Upgrade Guide

NonStop Software Essentials runs the Build/Apply requests and displays a Status page
that is automatically updated at regular intervals.
4. Check EMS messages for more detailed information about your Build/Apply:
• Click the system name in the System column to view EMS events on that system for this
Build/Apply request.
• When finished viewing, close the window.
5. To confirm that the Build and Apply tasks finish successfully and that a snapshot has been
received into the host database, wait until the status shows that all activities are complete.
Run the INSTALL^TEMPLATES Macro
EMS templates are used by EMS to format EMS messages. After running ZPHIRNM, and if notified
to do so by DSM/SCM, run the INSTALL^TEMPLATES TACL macro to install DSM/SCM EMS
templates in their proper locations.
NOTE: The files newres and newnres are used as temporary names until the next SYSGEN
and system load.
The INSTALL^TEMPLATES macro is located in the $SYSTEM.ZINSAIDS subvolume and invokes the
TEMPLI program to build new resident and nonresident EMS template files.
You must be logged on as a super.super (255, 255) user to run the INSTALL^TEMPLATES macro.
This macro cannot be run with the NOWAIT option and takes approximately ten minutes to finish.
For detailed instructions on running the INSTALL^TEMPLATES macro, including troubleshooting
information, see “If Running INSTALL^TEMPLATES Is Required” (page 161).
176 Copying the DSM/SCM, NonStop Software Essentials, and SWID SPRs from the SUT Using NonStop Software Essentials