H06.27 Software Installation and Upgrade Guide

Rename the Applied DSM/SCM H02 Files By Running ZPHIRNM
1. Stop DSM/SCM:
> VOLUME $dsmscm_vol.ZDSMSCM
> RUN STOPSCM
where $dsmscm_vol is the DSM/SCM volume.
2. Run ZPHIRNM:
> RUN ZPHIRNM $volume.SYSnn
where SYSnn is the current SYSnn (because no SYSGEN or system load is required).
3. When asked if you want to use a log file with the session, enter Y.
4. When prompted, enter a file name for the log file.
ZPHIRNM displays this message:
Log file, filename, was successfully created.
ZPHIRNM processes the file renaming.
5. Verify that ZPHIRNM ran successfully by reviewing the specified log file. For an example of
output, see“ZPHIRNM” (page 112).
Run the INSTALL^TEMPLATES Macro
EMS templates are used by EMS to format EMS messages. After running ZPHIRNM, and if notified
to do so by DSM/SCM, run the INSTALL^TEMPLATES TACL macro to install DSM/SCM EMS
templates in their proper locations.
NOTE: The files newres and newnres are used as temporary names until the next SYSGEN
and system load.
The INSTALL^TEMPLATES macro is located in the $SYSTEM.ZINSAIDS subvolume and invokes the
TEMPLI program to build new resident and nonresident EMS template files.
You must be logged on as a super.super (255, 255) user to run the INSTALL^TEMPLATES macro.
This macro cannot be run with the NOWAIT option and takes approximately ten minutes to finish.
For detailed instructions on running the INSTALL^TEMPLATES macro, including troubleshooting
information, see “If Running INSTALL^TEMPLATES Is Required” (page 161).
Restart Applications
You can now start your application software. Follow your site’s procedures for executing the system
configuration and startup (command) files to accomplish this.
DSM/SCM is often started automatically by a system command file. If not, you must start DSM/SCM
manually as described next.
Before Starting DSM/SCM
1. Check that TMF is started:
> TMFCOM STATUS TMF
2. Verify your current configuration against the cold start configuration in PATHHOST (or
PATHTARG) to check that the current configuration reflects all changes you have made.
3. If necessary, run the PATHCOLD macro from the ZDSMSCM subvolume to cold start the
Pathway configuration.
Start DSM/SCM
1. Run the STARTSCM macro from the ZDSMSCM subvolume to start DSM/SCM:
Rename the Applied DSM/SCM H02 Files By Running ZPHIRNM 185