H06.27 Software Installation and Upgrade Guide

Managing SWAN and SWAN 2 Concentrator Firmware
Both SWAN and SWAN2 are supported in H-series RVUs and OSM is used to update the firmware.
SCF can also be used. For procedures to update the firmware, see either the SWAN Concentrator
Installation and Support Guide or the SWAN 2 Concentrator Installation and Support Guide.
NOTE: Firmware levels for each component are located in the NonStop Firmware Matrices
document.
Managing NonStop Cluster Switch Firmware
To monitor and manage a ServerNet Cluster product configured with 6780 switches, use either
the OSM Service Connection or SCF commands. See the ServerNet Cluster 6780 Operations
Guide for more information.
For information on required software, installation, migration, and fallback procedures, see the
ServerNet Cluster 6780 Planning and Installation Guide.
Table 5 (page 35) lists the file name and locations for the updateable firmware information for the
cluster switch. Check with Scout for the latest SPRs. See the NonStop Firmware Matrices document
at: www.hp.com/go/nonstop-docs for product levels.
Table 5 Updateable Firmware for the NonStop 6780 ServerNet Switch File Names and Locations
Related
InformationToolDefault LocationFile NameComponentFirmware Name
ServerNet Cluster
6780 Operations
Guide
SCF or OSM SCSYSnn subvolumeM27896780 ServerNet
Switch
Logic board
configuration
firmware
ServerNet Cluster
6780 Operations
Guide
SCF or OSM SCSYSnn subvolumeC27906780 ServerNet
Switch (logic
board)
Router-2 ASIC*
firmware
ServerNet Cluster
6780 Operations
Guide
SCF or OSM SCSYSnn subvolumeLBC28196780 ServerNet
Switch (FPGA** in
logic board)
Cluster switch
firmware
Managing CLIM Firmware
If your system has CLIMs attached, it is very important that your CLIM firmware is compatible with
your system. Refer to the NonStop Firmware Matrices, located in the Service and maintenance
information section of the HP Integrity NonStop Service Information collection of the NonStop
Technical Library at http://www.hp.com/go/nonstop-docs, and ensure you have compatible
firmware levels for all CLIM components.
For instructions on upgrading CLIM firmware when a system is halted and when it is running, see
the Cluster I/O Protocols (CIP) Configuration and Management Manual.
In the past, the OSM Service Connection was used to perform the upgrade. The Down System
CLIM Firmware Update Tool now provides a faster, more efficient method for updating CLIM
firmware in a single action while the system is halted during an RVU upgrade. To use this method,
you must have:
• OSM Service Connection version T0682H02^ACV or later.
• OSM Console Tools product T0634 G06 ABB or later. When installed on the NonStop system
console (as part of OSM Console Tools), the Down System CLIM Firmware Update Tool is
launched from the Windows Start menu by selecting All Programs > HP OSM > Down System
CLIM Firmware Update Tool. For information on installing OSM Console Tools, see the NonStop
System Console Installer Guide.
Managing SWAN and SWAN 2 Concentrator Firmware 35