J06.04 Software Installation and Upgrade Guide

5. Repeat for the other ServerNet Switch.
6. If the system includes an (optional) enclosure 101, repeat the process for both switches in that
enclosure. (The switches in Enclosure 101 are labeled 101.2.5 and 101.3.7.)
Updating ME FPGA
Table 3 shows the current ME FPGA information for IOAMs:
Table 3 Maintenance Entity (ME) FPGA
Default LocationDisk File NameHost FRUDescriptionProduct Number
SYSnnSAM0815ServerNet Switch
(c7000 enclosure)
ME FPGA (see
Caution below)
T0815H01
SYSnnSAM0437ServerNet Switch
(IOAM enclosure)
ME FPGA (see
Caution below)
T0437A01^AAB
CAUTION: You should not use the Multi-Resource Actions dialog (in the OSM Service Connection)
to update ME FPGA simultaneously on both fabrics, or a system outage might occur.
Use the OSM Service Connection to check and (if necessary) update the ME FPGA for all c7000
enclosures and IOAMs just as you did when updating ME firmware, but choose the ME FPGA
Update action instead.
For information on using the OSM Low-Level Link to update ME FPGA, see the online help available
within the application.
Managing Server Blade Firmware
This table shows the minimum required versions for the Server Blade firmware products.
Table 4 Server Blade Firmware Minimum Required Versions
Product DescriptionProduct LevelModule File NameFirmware Product
Firmware used to reset, halt, load, and
dump a Server blade.
T8004*HSSFIRMW
or
HSSFWAAE
Halted State Services
(HSS) firmware
Controller firmware for legacy I/O or
SCSI disks in G-series RVUs.
T0480H01ISPFIRMWISP1040 firmware
Diskboot is used during a system load of
a NonStop BladeSystem.
T2773H01^AABDSKFIRMWDISKBOOT firmware
*VPROC shows HSS version as T0287H01^AAD.
These firmware products are all included in the HSS distribution. The installation procedure is
described in the NonStop System Console Installer Guide.
Managing ServerNet Adapter Firmware
This manual covers only the ServerNet adapters supported in I/O adapter modules (IOAMS):
• Fibre Channel ServerNet adapter (FCSA)
• Gigabit Ethernet 4-port ServerNet adapter (G4SA)
To update firmware for ServerNet adapters connected to legacy IOMF2 CRUs, see the latest
G-series Software Installation and Upgrade Guide.
20 Managing Microcode and Firmware for NonStop BladeSystems