J06.04 Software Installation and Upgrade Guide

4 Upgrade Checklist
Use the checklist in Table 9 as you perform the tasks required to upgrade to the J06.04 RVU and
the checklist in Table 10 (page 27) to record the information needed when performing these tasks.
You might have to update the service processor (SP) firmware on NonStop S-series systems for
IOMF2 PMF customer-replaceable units (CRUs).
J06.04 Upgrade Checklist
Table 9 J06.04 Upgrade Checklist
Done?ReferenceTask Description
Appendix B: “ Installing SWID, DSM/SCM PVU, and
Planner Interface (PI) Client Software ”
1. Install the DSM/SCM client and
server PVU (if necessary).Update
DSM/SCM EMS template files (if
necessary).
“Save the Current Configuration File (CONFxxyy)”
(page 30)
2. Save current system configuration
file.
Appendix A: “Using DSM/SCM to Install SPRs”3. Install required or recommended
fallback SPRs (if necessary).
“Updating System Consoles (Optional)
S7X-SWV2/HNSC-SWV2, Update 5” (page 13)
4. Upgrade system console software.
NonStop System Console (NSC) Installer Guide5. Install the latest HSS firmware (if
necessary) (includes DISKBOOT and
ISP1040 firmware).
“Verify System Processes” (page 30)6. Verify system operations.
“Receive New Software Into the Archive” (page 38)7. Receive J06.04 SUT into the
DSM/SCM software archive.
“Create a New Software Revision” (page 43)8. Create J06.04 software
configuration revision.
“Build and Apply the New Software Revision” (page 47)9. Build and apply J06.04 software
revision.
“Print Operator Instructions From the Target Interface
(ZPHITI)” (page 52)
10. Print the DSM/SCM Operator
Instructions.
Chapter 7: “Running ZPHIRNM ”11. Run ZPHIRNM.
“Halt the Processors” (page 64)12. Halt processors.
“While the Processors are Halted” (page 64)13. If HSS firmware is being
upgraded, hard reset the processors.
“Updating ME Firmware” (page 19)14. Update Blade ME firmware
(NonStop Carrier Grade
BladeSystems).
“Managing Maintenance Entity (ME) Firmware and ME
FPGA Firmware” (page 18) and the CSSI web page
15. Update IOAM firmware.
This update is done through a Field Change Order
(FCO).
16. Update C7000 Enclosure
firmware (if necessary).
“Loading the System” (page 64)17. Load the system with the new
J06.04 RVU.
“S-Series Interoperability Firmware” (page 23)18. Update S-series interoperability
firmware.
26 Upgrade Checklist