J06.05 Software Installation and Upgrade Guide

7 Installing a SUT for This RVU Using the Planner Interface
Alerts for Installing a SUT
Do not use this procedure to upgrade more than one system at a time or to install SPRs. For SPRs,
see “Using DSM/SCM and Planner Interface to Install SPRs” (page 133).
Before you install a SUT or RVU, these requirements must be met:
• When managing OSS files with DSM/SCM, check that the OSS Root Name Server $ZPNS
is started and running on the DSM/SCM Target. (See “Create a New Software Revision”
(page 63).) The volume where the SYSnn is being placed must be activated as $SYSTEM to
install the OSS files. See the Open System Services Management and Operations Guide, or
if using EasySetup, see the Open System Services Installation Guide.
• Save the configuration database. See “Save the Current Configuration File (CONFxxyy)”
(page 37).
• Verify your system operations. See “Verify System Processes” (page 38).
• If necessary, update the system console.
• Obtain a user name and password authorized to use the DSM/SCM Planner Interface. See
the DSM/SCM User’s Guide for more information about configuring which users are allowed
to use DSM/SCM and which tasks they are permitted to perform.
NOTE: Safeguard aliases are case-sensitive, and they must be entered exactly when you
log onto DSM/SCM.
You can add a Safeguard alias anytime Safeguard is running.
Before using an existing alias for DSM/SCM, check that Safeguard is started. Aliases are
available only while Safeguard is running.
• Pause the hometerm configured for use by DSM/SCM Pathway servers and other processes
when DSM/SCM is running. The default hometerm is $ZHOME. See the DSM/SCM User’s
Guide for more information about the hometerm used by DSM/SCM Pathway servers.
• For those OSS products that are not managed by DSM/SCM, you must install them manually
using PINSTALL or COPYOSS.
Back Up Important Files
• If you have already done so, you should back up important files (such as, TMF, NonStop
SQL/MP, NonStop SQL/MX, CLIM, and so forth). See “Back Up Important Files” (page 36).
• Drain the spooler and back up spooler control files.
Receive New Software Into the Archive
1. Start TMF and DSM/SCM if they are not already running. For example:
> TMFCOM START TMF
> VOLUME $dsmscm_vol.ZDSMSCM
> RUN STARTSCM
startscm
NOTICE: * If the hometerm chosen during INITENV, $zhome,
* is not currently in a paused state, STARTSCM and DSM/SCM
* server processes may hang indefinitely. Be sure this
* hometerm has been paused!
Alerts for Installing a SUT 59