J06.07 Software Installation and Upgrade Guide

3. Verify that the NonStop operating system is working properly:
a. Check the startup TACL window to verify that the startup scripts completed successfully.
b. Check the startup event stream window and the startup TACL window for error messages.
4. Close the System Startup dialog box.
For more information on system loads, see the NonStop Operations Guide.
Updating Firmware (If Necessary)
Update the following firmware as necessary:
• FCSA firmware
• G4SA firmware
• Any additional Server Blade firmware updates (for NonStop BladeSystems only) (HSS,
DISKBOOT, and ISP1040 are installed from the NonStop System Console DVD; if necessary,
PAL/SAL, EFI, and iLO 2 are installed through an FCO.)
• Any additional Blade firmware, if applicable to your system
• ServerNet Adapter firmware
• ServerNet Clustering firmware
• c7000 enclosure firmware, including the Onboard Administrator (OA) firmware, if applicable
to your system. See the NonStop Firmware Matrices document for the minimum required
version for this RVU.
• c7000 enclosure ServerNet Switch firmware (ME and ME FPGA), if applicable to your system
• IOAM ServerNet Switch firmware (ME and ME FPGA), if applicable to your system
• VIO enclosure firmware (ME and FPGA), if applicable to your system
• S-series interoperability firmware (Service Processor and Service Processor B), if applicable
to your system
• SWAN/SWAN2 Concentrator firmware
• SS7 controller firmware, if applicable to your system
• CLIM firmware, if your system has CLIMs attached, and you did not update CLIM firmware
while the system was down. See the NonStop Firmware Matrices for details.
See Chapter 2: “Managing Microcode and Firmware” for a description of the firmware installation
procedure.
To find out what firmware is required for your system, see the appropriate planning guide.
92 Loading This RVU