J06.09 Software Installation and Upgrade Guide

After a brief pause during which the ProLiant window appears, a screen showing a successful
installation like this appears:
Prepare the CLIMs
This procedure is necessary only if you reimaged a CLIM to revert CLIM software.
1. For each CLIM, set the IP address of eth0 through the iLO serial console.
a. At the Linux prompt, log onto the CLIM. CLIMs are shipped with two default maintenance
interface usernames and passwords:
• root/hpnonstop
• user/clim
b. At the Linux prompt, add the interface by entering this command:
climconfig interface –add eth0
c. Add the IP address and bring up the eth0 interface by entering:
climconfig ip –add eth0 –ipaddress ip-address -netmask netmask
2. Reboot the CLIMs by entering:
reboot
3. Use OSM Low-Level Link to perform the Configure action on each CLIM. In the Configure CLIM
dialog box, enter all the information that you gathered before starting this procedure. (In
pre-ABK versions of OSM Low-Level Link, the PCI Slot Configuration area shows the
possible PCI slot configurations in multiple drop-down menus. (This area is disabled for Storage
CLIMs.))
Sample Pre-ABK Version of OSM Low-Level Link, IP CLIM
122 Falling Back on the CLIMs, Loading the Previous RVU, and Resuming Normal Operations