J06.09 Software Installation and Upgrade Guide

If the reload is initiated successfully, this message appears in a startup TACL window on the
system console screen:
PROCESSOR RELOAD: nn
Complete CLIM Setup
1. Establish trust between the CLIM and the NonStop host system.
Run SSOCLIM as any SUPER group user. You must run SSOCLIM twice, once with the root
username and hpnonstop password, and once with the user username and clim password.
a. At a TACL prompt, log on as any SUPER group user.
b. Enter SSOCLIM.
The script prompts you for the CLIM name, IP address or DNS name of the CLIM. Enter
that parameter. Then the script prompts you for the username and password. Use the
root username and hpnonstop password.
c. Re-enter the SSOCLIM command using the user username and clim password.
2. Use CLIMRSTR to restore all the CLIMs with the CLIM backup files from the previous CLIM
version. Restore the files that you stored when you followed the CLIM software upgrade
procedures in “Back Up CLIM Configuration Files” (page 39).
NOTE: The CLIM configuration files used during this procedure must be of the same RVU as
the RVU to which you are falling back.
For the J06.04 and J06.05 RVUs, rename and restore the backup files. For example, at the
TACL prompt, enter:
a. >FUP RENAME $DATA1.BCKJ0605.N1002583, $DATA1.BCKJ0605.BACKUPGZ
b. >CLIMRSTR N1002583 $DATA1.BCKJ0605
c. Repeat steps a. and b. for each CLIM.
For J06.06 and later RVUs, restore the backup files. For example, at the TACL prompt, enter:
a. >CLIMRSTR N1002583 $SYSTEM.N102583.BCKJ0606
b. Repeat for each CLIM.
3. Reboot the CLIMs:
a. For large systems, boot one of every pair of CLIMs on the system at the same time.
NOTE: For IP CLIMs you must know which CLIMs are configured as failover pairs. For
Storage CLIMS, you must know which pair of CLIMs are attached to a particular path or
you will lose access to the disk.
b. Wait for all the CLIMs to be restored and wait for disk paths or IP addresses to return
before rebooting the next CLIM.
For Storage CLIMs, use SCF status disk $*. For IP CLIMs, use CLIMCMD psclim.
>climcmd n1002583 psclim
If you do not see any running processes, use the CLIM command to clear the log and
start. For example (IP CLIM):
>climcmd n1002583 clim clearlog; clim start
For Storage CLIMs, after clearlog, you must reboot again. For example (Storage CLIM):
>climcmd s1002533 clim clearlog
>climcmd s1002533 clim reboot-nodebug
128 Falling Back on the CLIMs, Loading the Previous RVU, and Resuming Normal Operations