J06.09 Software Installation and Upgrade Guide

D Installing SWID, DSM/SCM PVU, and Planner Interface (PI) Client Software ..153
Alerts..................................................................................................................................153
Determine the Product Version of DSM/SCM on the Host System............................................153
Determine the Latest SWID Product.....................................................................................153
Determine the Product Version of DSM/SCM on the Client....................................................153
Copy (RESTORE) the H02 DSM/SCM Product Version to Disk (If Necessary).................................154
Receive the H02 SWID and DSM/SCM SPRs ..........................................................................154
Create a New Software Revision for H02 DSM/SCM and SWID SPRs ........................................156
Build and Apply the DSM/SCM H02 Software Product Revision.................................................156
Rename the Applied DSM/SCM H02 Files By Running ZPHIRNM...............................................158
Run the INSTALL^TEMPLATES Macro.......................................................................................158
Restart Applications..............................................................................................................158
Before Starting DSM/SCM................................................................................................158
Start DSM/SCM..............................................................................................................158
Verify that the Correct SPR of DSM/SCM is Installed.............................................................159
Verify That SWID Is Installed..............................................................................................159
Recovery for Problems While Installing the H02 Version of DSM/SCM .......................................159
If NonStop Errors Are Displayed........................................................................................160
Cancel Pending Build/Apply Requests...........................................................................160
Install the DSM/SCM Client From ZDSMSCM ..........................................................................160
Determine Your DSM/SCM Client Software Version..............................................................160
Determine the Current IP Address and Port Number..............................................................160
Copy the ZDSMSCM Client File From the Host.....................................................................161
Install the DSM/SCM Client Software.................................................................................162
E Updating SWAN Concentrator CLIP Firmware............................................167
Acronyms.................................................................................................168
Index.......................................................................................................170
8 Contents