J06.11 Software Installation and Upgrade Guide

Table 4 Server Blade Firmware for All NonStop System Running J-Series Software Except for the
NS2000 Series System
Product DescriptionFirmware Name
Used to reset, halt, load, and dump a server blade. Delivered as an
Independent Product on the NSC DVD.
Halted State Services firmware
Controller firmware for legacy I/O or SCSI disks in G-series RVUs.ISP1040 firmware
Used during a system load.DISKBOOT firmware
Table 5 Blade Element Firmware for NonStop NS2000 Series Systems
Product DescriptionFirmware Name
Used to reset, halt, load, and dump a blade element. Delivered as
an Independent Product on the NSC DVD.
Halted State Services and HPI Loader T8004
Firmware
Controller firmware for legacy I/O or SCSI disks in G-series RVUs.
This firmware is packaged as part of the DVD containing T8004 and
cannot be updated independently.
ISP1040 Firmware
Used during a system load. This firmware is packaged as part of the
DVD containing T8004 and cannot be updated independently.
DISKBOOT Firmware
The installation procedure for blade element firmware is described in the Updating Blade Element
Firmware in an NS2200 Series, NS2100, NS2000 Series, NS1200 or NS1000 Server service
procedure.
Managing ServerNet Adapter Firmware
Table 6 (page 25) identifies the ServerNet adapters that can be installed in or connected to J-series
NonStop systems.
Table 6 ServerNet Adapters Used With J-Series NonStop Systems
Where Adapter Is InstalledServerNet Adapter
IOAM enclosure in a NonStop BladeSystemFibre Channel ServerNet Adapter (FCSA)
IOAM enclosure in a NonStop BladeSystemGigabit Ethernet 4-port ServerNet Adapter
(G4SA)
I/O enclosure in a NonStop S-series system connected to ServerNet
switches in a NonStop BladeSystem c7000 enclosure
6763 Common Communication ServerNet
Adapter (CCSA)
I/O enclosure in a NonStop S-series system connected to ServerNet
switches in a NonStop BladeSystem c7000 enclosure
Token Ring ServerNet Adapter (TRSA)
To determine if the firmware for an installed FCSA, GS4A, or CCSA adapter needs to be updated,
navigate down the OSM tree pane for FCSA, G4SA, or CCSA:
CAUTION: Ensure that the system is running the new RVU before starting this procedure.
Managing ServerNet Adapter Firmware 25