J06.11 Software Installation and Upgrade Guide

Table 13 Upgrade Checklist (continued)
Done?ReferenceTask Description
SUM), a power cycle has occurred
and hard resetting the processors
again is not necessary.
This update is done through a Field Change Order (FCO).22. Update c7000 Enclosure
firmware, if necessary.
Cluster I/O Protocols (CIP) Configuration and
Management Manual
23. Update CLIM software on all
CLIMs using the procedure
Performing the “CLIM Software
Upgrade Using OSM Low-Level Link.”
(If you are migrating from J06.06 or
later and performed an online
upgrade of the CLIM to the CLIM
software released with this RVU
before starting the host system
upgrade, you can skip this step.)
“8. Loading the System” (page 95)24. Load the system with new this
RVU.
“Managing S-Series Interoperability Firmware” (page 29)25. Update S-series interoperability
firmware, if necessary.
“Updating ME Firmware” (page 22)26. Update ME and ME FPGA
firmware, if necessary.
“Managing ME Firmware and ME FPGA Firmware”
(page 22) and the CSSI web page
27. For systems with IOAMs, update
IOAM firmware, if necessary.
“Managing ServerNet Adapter Firmware” (page 25)28. Update FCSA firmware, if
necessary.
“Managing ServerNet Adapter Firmware” (page 25)29. Update G4SA Boot firmware, if
necessary.
This update is done through a Field Change Order (FCO).30. Update remaining server blade
firmware, if necessary.
“Managing ServerNet Adapter Firmware” (page 25)31. Update G4SA Download Code
firmware, if necessary.
“5. (Required Only for Upgrade from J06.13 or Earlier
to J06.14 or Later) Perform a Hard Reset” (page 94)
32. If a hard reset of the processors
was successful in Step24, a reset is
not required again for systems
migrating to J06.14 or a later RVU
“7. (Optional) Update the CLIM Firmware” (page 94)33. Update firmware for CLIM
components, if necessary.
“5. (Required Only for Upgrade from J06.13 or Earlier
to J06.14 or Later) Perform a Hard Reset” (page 94)
34. If a hard reset of the processors
was successful in Step24, a reset is
not required again for systems
migrating to J06.14 or a later RVU.
“Update NonStop TCP/IP Configuration Files” (page 102)35. Recover TCP/IP files, if
necessary.
“Check Processor Status” (page 45)34. Check processor status.
“Configure the WAN Manager” (page 105)36. Configure WANMGR, if
necessary.
SWAN Concentrator Installation and Support Guide or
SWAN 2 Concentrator Installation and Support Guide
37. Update SWAN concentrator CLIP
firmware, if necessary.
“Start System Applications” (page 100)38. Start system software.
Upgrade Checklist 41