J06.12 Software Installation and Upgrade Guide

SYSTEM STARTUP COMPLETE,
NSK RUNNING ON PROCESSOR n
• If the system load fails, check for the appearance of any halt codes or messages. For
recovery procedures, see the Processor Halt Codes Manual or Operator Messages Manual.
• After the operating system is running on the server, messages are no longer sent to the
Details box. See the event messages sent to the startup event stream window.
Complete the System Load (If Necessary)
Loading the processors with the CIIN file is usually automatic. However, if the operating system
loaded successfully into processor 0 or processor 1, but the commands in the CIIN file do not
reload all remaining processors, use the following TACL RELOAD command. You must be super
ID (255,nnn) to load the processors.
1. From the system console, log on to the system as a super-group user (255,nnn) and enter:
TACL> RELOAD *, PRIME
2. To load an individual processor, enter:
TACL> RELOAD nn
where nn is the processor number of the processor you want to reload.
If the reload is initiated successfully, this message appears in a startup TACL window on the
system console screen:
PROCESSOR RELOAD: nn
Complete CLIM Setup
1. Establish trust between the CLIM and the NonStop host system.
If you are falling back to J06.09 (or to an RVU with T0682H02^ACC) or J06.10 (or to an
RVU with T0682H02^ACI), you must run SSOCLIM as SUPER.SUPER.
In all cases, you must run SSOCLIM twice, once with the root username and hpnonstop
password, and once with the user username and clim password.
a. At a TACL prompt, log on as SUPER.SUPER (for a fallback to J06.09 or J06.10) or as
any SUPER group user (for a fallback to J06.08 or earlier or J06.11).
b. Enter SSOCLIM.
The script prompts you for the CLIM name, IP address or DNS name of the CLIM. Enter
that parameter. Then the script prompts you for the username and password. Use the
root username and hpnonstop password.
c. Re-enter the SSOCLIM command using the user username and clim password.
2. Use CLIMRSTR to restore all the CLIMs with the CLIM backup files from the previous CLIM
version. Restore the files that you stored when you followed the CLIM software upgrade
procedures in “Back Up CLIM Configuration Files” (page 42).
NOTE: The CLIM configuration files used during this procedure must be of the same RVU as
the RVU to which you are falling back.
For the J06.04 and J06.05 RVUs, rename and restore the backup files. For example, at the
TACL prompt, enter:
Complete CLIM Setup 123