J06.14 Software Installation and Upgrade Guide

1. Configure the WAN manager as described in the WAN Subsystem Configuration and
Management Manual.
2. Update the SWAN CLIP firmware. See either the SWAN Concentrator Installation and Support
Guide or the SWAN 2 Concentrator Installation and Support Guide.
Set Up iTP WebServer
If iTP WebServer was installed and was being used with the previous RVU, the same iTP WebServer
installation would not work after the RVU upgrade. To get the iTP WebServer installation working
(both T8996 and T8997) after an RVU upgrade, you must re-configure and set up iTP WebServer
at the same OSS location using the setup script.
See the Release Version Update Compendium for your J-series RVU for new feature information.
Re-deploy NonStop SOAP 4
If NonStop SOAP 4 was deployed and was being used with the previous RVU, the same SOAP 4
installation would not work after the RVU upgrade. To use NonStop SOAP 4 after an RVU upgrade,
you must deploy the NonStop SOAP 4 version available with the new RVU in the existing NonStop
SOAP 4 deployment directory, using the NonStop SOAP 4 deploy script.
Configure Specific Products (Post-System Load) 107