J06.14 Software Installation and Upgrade Guide

9 Loading This RVU
This chapter describes how to perform a system load on this RVU into the memory of each processor
in a NonStop system.
NOTE: For additional information about performing a system load of a NonStop system, see the
NonStop Operations Guide.
By default, one $SYSTEM is already configured. You can select $SYSTEM, FCDM-Load,
CLIM-Attached-Load, or an alternate system volume:
The $SYSTEM disks must contain the current RVU operating system files for the NonStop system.
Table 19 (page 89) and Table 20 (page 89) identifies the possible load paths you would use to
perform an FCDM-Load and a CLIM-Attached-Load, respectively.
Table 19 System Load Paths in Order of Use for FCDM-Load
Over ServerNet FabricTo ProcessorData Travels FromDescriptionLoad Path
X0$SYSTEM-PPrimary1
Y0$SYSTEM-PPrimary2
X0$SYSTEM-BBackup3
Y0$SYSTEM-BBackup4
X0$SYSTEM-MMirror5
Y0$SYSTEM-MMirror6
X0$SYSTEM-MBMirror backup7
Y0$SYSTEM-MBMirror backup8
X1$SYSTEM-PPrimary9
Y1$SYSTEM-PPrimary10
X1$SYSTEM-BBackup11
Y1$SYSTEM-BBackup12
X1$SYSTEM-MMirror13
Y1$SYSTEM-MMirror14
X1$SYSTEM-MBMirror backup15
Y1$SYSTEM-MBMirror backup16
Table 20 System Load Paths in Order of Use for CLIM-Attached-Load
Over ServerNet FabricTo ProcessorData Travels FromDescriptionLoad Path
X0$SYSTEM-PPrimary1
Y0$SYSTEM-PPrimary2
Y0$SYSTEM-BBackup3
X0$SYSTEM-BBackup4
X0$SYSTEM-MMirror5
Y0$SYSTEM-MMirror6
Y0$SYSTEM-MBMirror backup7
X0$SYSTEM-MBMirror backup8
89