J06.15 Software Installation and Upgrade Guide

Verify that the SUT Version of SWID Is Installed....................................................................152
Recovery for Problems While Installing the H02 Version of DSM/SCM .......................................152
If NonStop Errors Are Displayed........................................................................................152
Cancel Pending Build/Apply Requests...........................................................................152
Install the Latest Version of the NonStop Software Essentials Client...............................................153
D Copying the DSM/SCM and SWID SPRs from the SUT Using the Planner
Interface...................................................................................................154
Alerts..................................................................................................................................154
Determine the Product Version of DSM/SCM on the Host System and SUT...............................154
Determine the SWID Product Version on the Host System and SUT..........................................154
Determine the Product Version of DSM/SCM on the Client....................................................154
Copy (RESTORE) the H02 DSM/SCM Product Version to Disk (If Necessary).................................155
Receive the H02 SWID and DSM/SCM SPRs ..........................................................................155
Create a New Software Revision for H02 DSM/SCM and SWID SPRs ........................................157
Build and Apply the DSM/SCM H02 Software Product Revision.................................................157
Rename the Applied DSM/SCM H02 Files By Running ZPHIRNM...............................................159
Run the INSTALL^TEMPLATES Macro.......................................................................................159
Restart Applications..............................................................................................................159
Before Starting DSM/SCM................................................................................................159
Start DSM/SCM..............................................................................................................159
Verify That the Correct SPR for DSM/SCM is Installed...........................................................160
Verify That SWID Is Installed..............................................................................................160
Recovery for Problems While Installing the H02 Version of DSM/SCM .......................................160
If NonStop Errors Are Displayed........................................................................................161
Cancel Pending Build/Apply Requests...........................................................................161
Install the DSM/SCM Client From ZDSMSCM ..........................................................................161
Determine Your DSM/SCM Client Software Version..............................................................161
Determine the Current IP Address and Port Number..............................................................161
Copy the ZDSMSCM Client File From the Host.....................................................................162
Install the DSM/SCM Client Software.................................................................................163
E Updating SWAN Concentrator CLIP Firmware............................................165
Acronyms.................................................................................................166
Index.......................................................................................................168
Contents 9