J06.16 Software Installation and Upgrade Guide

you have installed on your NonStop system console is launched from the Windows Start
menu by selecting All Programs>HP OSM>, followed by the name of the wizard.
NOTE: For detailed information about the appearance of and instructions for using the
wizard you have installed on your NonStop system console, see the online help for that
wizard.
c. If the wizard confirms that any of the CLIMs you are downgrading are being used for
DHCP, DNS, and BOOTP services, check the listed IP addresses to see if they correspond
to the CLIMs you are downgrading. For information on how to use the wizard, see the
online help for the wizard you are using.
NOTE: If any CLIMs to be downgraded are being used for those services, you will use
this information later, during the the fallback step “If Using CLIMs for BOOTP, DHCP, or
DNS Services” (page 124)
6. Obtain the system name, netmask, gateway, and IP address for the CLIMs. If this information
is unavailable from your environmental documentation, continue with the next step to obtain
it directly from your system. Otherwise, skip the next step.
7. Obtain and record the current CLIM configuration information:
a. Using the SCF INFO CLIM, DETAIL command, obtain the maintenance interface IP address
and NonStop host system name of the CLIM(s) to be downgraded. For example:
->INFO CLIM $ZZCIP.N1002583, DETAIL
The NonStop host system name in this example is \BLJCQA2 and the maintenance
interface IP address is 192.168.37.83.
b. Use the climcmd clim-name climconfig interface -info eth0 command
from a TACL prompt for the CLIMs to obtain the netmask and gateway. For example:
>climcmd N1002583 climconfig interface -info eth0
comForte SSH client version T9999J06_07Jul2008_comForte_SSH_0080
Interface : eth0
Interface Type : Physical Interface
Jumbo Frame : NO
IP Address : 192.168.37.83
Netmask : 255.255.0.0
In this example, the netmask is 255.255.0.0 and there is no gateway configured.
c. Use OSM Low-Level Link to connect to the CLIM and obtain PCI Slot configuration
information.
d. Make note of all values.
When Falling Back to the J06.04 or Earlier RVU
Modify OSSINFIL
You must restore the SERVER #ZPLS entry in the OSS subsystem maintenance file OSSINFIL on all
systems with OSS installed before halting the processors to fall back to J06.04 or earlier RVUs. If
you commented out this entry when installing this RVU, use TEDIT to modify the entry as follows:
TEDIT $SYSTEM.ZOSSINS.OSSINFIL
Then change
* SERVER #ZPLS
to
SERVER #ZPLS
This change is required for correct startup of OSS.
Before Halting the Processors 123