J06.16 Software Installation and Upgrade Guide

If the reload is initiated successfully, this message appears in a startup TACL window on the
system console screen:
PROCESSOR RELOAD: nn
Using the SSOCLIM * Option to Run SSOCLIM on All Available CLIMs
For this RVU, SSOCLIM can be made to run on all available CLIMs by using the * option instead
of the CLIM IP or CLIM name in the SSOCLIM command line:
SSOCLIM [{CLIM NAME | IP | *}{CLIM USER} {PASSWORD}][FORCED]
Where:
CLIM NAME
is the name of the CLIM to be used.
IP
is the IP address of the CLIM to be used.
*
runs SSOCLIM on all available CLIMs.
CLIM USER
is the user name to be used against a CLIM when CLIM NAME or IP is used or against all
available CLIMs when * is used.
PASSWORD
is the password to be used against a CLIM when CLIM NAME or IP is used or against all
available CLIMs when * is used.
FORCED
, if specified, suppresses the warning instruction to run SSOCLIM on all the CLIMs.
Complete CLIM Setup
1. Establish trust between the CLIM and the NonStop host system.
If you are falling back to J06.09 (or to an RVU with T0682H02^ACC) or J06.10 (or to an
RVU with T0682H02^ACI), you must run SSOCLIM as SUPER.SUPER.
In all cases, you must run SSOCLIM twice, once with the root username and hpnonstop
password, and once with the user username and clim password.
a. At a TACL prompt, log on as SUPER.SUPER (for a fallback to J06.09 or J06.10) or as
any SUPER group user.
b. Enter SSOCLIM.
The script prompts you for the CLIM name, IP address or DNS name of the CLIM. Enter
that parameter. Then the script prompts you for the username and password. Use the
root username and hpnonstop password.
c. Re-enter the SSOCLIM command using the user username and clim password.
2. Use CLIMRSTR to restore all the CLIMs with the CLIM backup files from the previous CLIM
version. Restore the files that you stored when you followed the CLIM software upgrade
procedures in “Back Up CLIM Configuration Files” (page 47).
NOTE: The CLIM configuration files used during this procedure must be of the same RVU as
the RVU to which you are falling back.
For the J06.04 and J06.05 RVUs, rename and restore the backup files. For example, at the
TACL prompt, enter:
130 Falling Back on the CLIMs, Loading the Previous RVU, and Resuming Normal Operations