J06.17 Software Installation and Upgrade Guide

a. At the Linux prompt, log onto the CLIM. CLIMs are shipped with two default maintenance
interface usernames and passwords:
• root/hpnonstop
• user/clim
b. At the Linux prompt, add the interface by entering this command:
climconfig interface –add eth0
c. Add the IP address and bring up the eth0 interface by entering:
climconfig ip –add eth0 –ipaddress ip-address -netmask netmask
2. Reboot the CLIMs by entering:
reboot
3. Use OSM Low-Level Link to perform the Configure action on each CLIM. In the Configure CLIM
dialog box, enter all the information that you gathered before starting this procedure. (In
pre-ABK versions of OSM Low-Level Link, the PCI Slot Configuration area shows the
possible PCI slot configurations in multiple drop-down menus. (This area is disabled for Storage
CLIMs.))
Sample Pre-ABK Version of OSM Low-Level Link, IP CLIM
In ABK and later versions of OSM Low-Level Link, the PCI Slot Configuration area has
the groups of possible IP CLIM configurations selectable from a single drop-down menu.
Sample ABK and Later Versions of OSM Low-Level Link, IP CLIM
128 Falling Back on the CLIMs, Loading the Previous RVU, and Resuming Normal Operations