J06.17 Software Installation and Upgrade Guide

You are now prompted to enter an IP port number for the Winsock service that is within a
specific range:
8. Enter the IP port number for the Winsock service (see “Determine the Current IP Address and
Port Number” (page 166)), and click Next.
NOTE: If DSM/SCM is not currently configured to communicate with a host system, accept
the default IP port number. You can always change this value later by editing the dsmscm.ini
file.
You are now prompted to enter the host system name.
9. Enter the host system name (or \noname if DSM/SCM is not currently configured to
communicate with a host system), and click Next to continue.
You are asked if you would like to run DSM/SCM. Click NO when you are asked if you would
like to run DSM/SCM.
10. Click No.
The setup program adds the DSM/SCM client software to the Windows Start>Programs menu.
You can start the DSM/SCM Planner Interface or CNFGINFO tool from the
Start>Programs>DSM_SCM submenu. For example:
Install the DSM/SCM Client From ZDSMSCM 169