J06.17 Software Installation and Upgrade Guide

Verify Disk Drives
1. Enter the SCF STATUS DISK command:
> SCF STATUS DISK $*
2. Verify that the STATUS DISK display includes all the disk drives and that the primary, backup,
mirror, and mirror-backup paths are all described as STARTED:
$SYSTEM TOOLS 48> SCF STATUS DISK $*
SCF - T9082H01 - (01MAY08) (15MAR08) - 07/06/2008 10:55:16 System \ATLAS
(C) 1986 Tandem (C) 2003 Hewlett Packard Development Company, L.P.
STORAGE - Status DISK \ATLAS.$SYSTEM
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
6 *STARTED STARTED STOPPED STOPPED 0,257 1,257
STORAGE - Status DISK \ATLAS.$AD01
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
152 *STARTED STARTED STOPPED STOPPED 0,333 1,288
STORAGE - Status DISK \ATLAS.$ADAUD
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
151 *STARTED STARTED *STARTED STARTED 0,332 1,289
STORAGE - Status DISK \ATLAS.$ADBIT
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
150 *STARTED STARTED *STARTED STARTED 0,331 1,290
STORAGE - Status DISK \ATLAS.$ADSAV
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
149 *STARTED STARTED STOPPED STOPPED 0,330 1,291
Total Errors = 0 Total Warnings = 0
$SYSTEM TOOLS 49>
Verify Tape Drives (If Necessary)
You can use SCF commands or OSM to obtain status information about a tape drive. Check that
the tape drive is online before continuing with installing SPRs, RVUs, or RVURs. OSM does not test
tape libraries.
1. Enter the SCF STATUS TAPE command:
> SCF STATUS TAPE $*
2. Verify that the STATUS TAPE display includes a least one tape drive configured and running,
as shown:
STORAGE - Status TAPE $T0150
LDev State Sub State Primary Backup Device Status
PID PID
71 STARTED UP 0,282 1,273 READY
Verify System Processes 55