NonStop Firmware Matrices

Supplementary Steps for Updating Firmware Components
Not Delivered on the SUT
This section contains extra guidance for updating non-SUT firmware components for those cases
where the instructions on the download page or with the firmware itself do not work or are not
complete for NonStop systems.
Updating BL860c i4 Blade System Firmware
1. Click the link to the selected firmware version for BL860c i4 blade located in NonStop
Supported Levels for J06.04–J06.17 and H06.15–H06.28 for Firmware Not Delivered on
the SUT (page 12).
If this link is invalid, follow the steps described in “Using the HP Business Support Center or
the HP Support Center to Download Firmware Components Not Delivered on the SUT”
(page 76).
2. On the firmware download web page, click the Installations Instructions tab. For reference
during the firmware update, copy or print the instructions.
For more information about the HP SUM tool, see the HP SUM User Guide:
http://h18004.www1.hp.com/products/servers/management/unified/hpsum_infolibrary.html
For system firmware bundle version 44.01, the HP SUM version is 5.3.5.
3. On the firmware download web page, click Download for the large (>100 MB) file, then save
the bundle to the NonStop System Console or a PC. If you download the bundle to a PC, copy
the bundle to the NonStop System Console on the dedicated LAN.
4. Verify the integrity of the downloaded file. The small (<100 Bytes) file on the firmware download
page contains the MD5 checksum for the large (>100 MB) file. To verify the integrity of the
large file:
a. Use an MD5 utility to calculate its checksum. For more information, see the instructions
for your MD5 utility.
b. To display the correct checksum value for the file in the browser, click the Download
button for the MD5 file.
c. Compare the calculated checksum value with the correct value. If the two values do not
match, the download might be corrupted. Download the large file again, then repeat the
MD5 verification.
5. Follow the steps in the Installation Instructions tab to extract the HP SUM and firmware
component files to the NonStop System Console.
6. To install the firmware components using the HP SUM - Graphical User Mode, follow the steps
in the Installations Instructions tab.
In the HP SUM Select Targets screen:
• Select or add the IP address for the blade to be updated. If HP SUM has been run
previously on the system, the Select Targets screen might already contain the target blade
IP address.
• When adding the IP address for a blade, an Associated Targets popup window appears.
This window shows the c7000 enclosure Onboard Administrator (OA) IP address as an
associated target for the blade. Click Deselect All, then click OK.
• The credentials for the blade are the iLO login user name and password.
Updating BL860c i4 Blade System Firmware 57