NonStop Firmware Matrices

ChangesDateVersion

◦ Updated SAS CG Disk Enclosure firmware level to AAH.

◦ Updated SWAN and SWAN 2 firmware level to AAS.

• Added an entry for NB56000c and NB56000c-cg (BL860c i4) and

information on bundle version 26.36 to “Valid System Firmware and HSS

Combinations” (page 50).

• Added information about NB56000c and NB56000c-cg (BL860c i4) and

information on bundle version 26.36 to “Identification of BL860c i4, BL860c

i2, rx2800 i2, and rx2800 i4 Server Firmware Versions” (page 54).

• Added “Updating BL860c i4 Blade System Firmware” (page 57).

• Updated “Updating Interconnect Ethernet Blade Switch (C7000) Firmware”

(page 68) with more details and clarifications. Removed step for disabling

TFTP. This is never necessary for NonStop system consoles.

• Corrected the CLIM SAS HBA, CLIM Smart Array Controller, and HSS,

PAL/SAL, Primitive State entries in “SUT Delivered NonStop Firmware Levels

for J06.15 and H06.26” (page 23).

• Made minor changes to “Updating ProCurve Maintenance Switch Firmware”

(page 72) for system consoles that do not run TFTP.

• Added a few missed references to NS2100.

• Updated references to Hotstuff HS03181D to Hotstuff HS03181E.

• Deleted references to SN S12040 as these are no longer applicable.

• Changed references to iLO firmware version 01.51.03 to 01.53.02 or earlier.

• Corrected CLIM Smart Array Controller firmware level for p420i.

• Updated information in “Valid System Firmware and HSS Combinations”

(page 50).

Made these changes:4 February 2013546227–023

• Updated the following in “NonStop Supported Levels for J06.04–J06.17 and

H06.15–H06.28 for Firmware Not Delivered on the SUT ” (page 12):

◦ Alarm panel for HP BladeSystems firmware identifier is changed from

1.0F.11 to 1.0F, and the link is updated; the firmware itself is unchanged.

◦ Added DC maintenance switch recommended firmware version 4.1.15.

◦ Added Interconnect Ethernet blade switch (C7000) recommended boot

image and firmware version 5.28.

◦ Added ProCurve maintenance switch J9019B (2510B-24) recommended

firmware version Q.11.57.

◦ Corrected documentation link for UPS (HP R5500XR).

◦ Added note to UPS (HP R5500XR) indicating that a serial terminal with a

Baud rate of 115200 is required to update firmware.

• Added the new section “SUT Delivered NonStop Firmware Levels for J06.15

and H06.26” (page 23). Edited this section to describe differences from the

previous RVU:

◦ Updated CLIM BIOS (ROM) G2/G5 and CLIM BIOS (ROM) G6 levels to

AAG.

◦ Added CLIM BIOS (ROM) Gen8

◦ Updated CLIM HCA level to AAF.

◦ Updated CLIM iLO level to AAG (firmware levels: 2.12 (iLO 2) and 1.13

(iLO 4)).