OSM Alarm Summary

OSM Alarm Summary – 541946-001 5
1.188 SWAN Memory Error
1.189 Network Error
1.190 SWAN I/O Process Error
1.191 SWAN IOP Line Parameter Error
1.192 SWAN Download Error
1.193 Power-on Self Test Not Run
1.194 Path A Down
1.195 Path B Down
1.196 CRU Storage Initialization Failed
1.197 Storage ASIC Initialization Failed
1.198 Data Miscompare Error on Attached Disk
1.199 Path Switch
1.200 Processor Switch on I/O Process
1.201 Backup Path Down
1.202 Primary Path Down
1.203 Both Paths Down
1.204 Data Integrity Error
1.205 Maximum Sector Spares For Life Exceeded
1.206 Maximum Sector Spares For Period Exceeded
1.207 Maximum Sector Rewrites For Period Exceeded
1.208 Uncorrectable Media Error
1.209 Primary and Backup Paths Configured to Different Disks
1.210 Same Physical Disk Configured as Primary and Mirror
1.211 Predictive Failure Analysis Threshold Reached For Recovered Errors
1.212 Recovered Error
1.213 No Index Signal Error
1.214 No Seek Complete Error
1.215 Peripheral Device Write Fault Error
1.216 Track Following Error
1.217 Data Synchronous Mark Error
1.218 Internal Target Failure
1.219 Medium Error
1.220 Software Error
1.221 Temperature Out of Limits in External Disk Module <Module ID>
1.222 Fan Failure in External Disk Module <Module ID>
1.223 Backup Power Supply Failure in External Disk Module <Module ID>
1.224 Primary Power Supply Failure in External Disk Module <Module ID>
1.225 Power Failure in Disk <N> in External Disk Module <Module ID>
1.226 SCSI Bus <N> Termination Power Failure in External Disk Module <Module ID>
1.227 Not Communicating
1.228 Unsupported Configuration
1.229 Storage Router Not Supported
1.230 Tape Path Down
Section 2 OSM Alarms for HP Integrity NonStop Servers
2.1 PE Cannot be reintegrated
2.2 Too Many Reintegration Operations
2.3 Too many reintegration failures
2.4 PE NonStop Blade Element Id Incompatibility
2.5 PE System Name Incompatibility
2.6 Maximum Three Slices
2.7 Incompatible Slice Hardware
2.8 Invalid Reintegration Cable Connections
2.9 Invalid Reintegration Cabling Between NonStop Blade Complexes
2.10 Reintegration Cable Crossover
2.11 NonStop Blade Complex Not Fault Tolerant
2.12 NonStop Blade Element Not Cabled To NonStop Blade Complex
2.13 Lower/Upper Reintegration Cable Connectivity Error
2.14 Memory Reintegration Board Initialization Error
2.15 NonStop Blade Element Hardware Error
2.16 Power Redundancy Loss
2.17 NonStop Blade Element Hardware Memory Error
2.18 BMC Hardware Error