ServerNet Cluster Web

Himalaya S-Series System Expansion and Reduction Guide

(PN426721-001, PN427555-001, and PN429228-001)

Problem: A caution on page 1-2 of the guide incorrectly states that if

a system you want to resize is a member of a ServerNet cluster and

you want to perform this expansion online, you must first remove the

system from the cluster.

Correction: There is no restriction for expanding or reducing a

system online when a system is a member of a ServerNet cluster.

Online expansion and reduction is fully supported for ServerNet

nodes.

ServerNet Cluster Manual (PN 425019-001)

Problem: Page 2-7 of the ServerNet Cluster Manual states that

single-mode fiber-optic cables provided by Compaq are not

plenum-rated.

Correction: An 80-meter plenum-rated cable is now available.

You can order the cable using:

order number 676-265P●

cable part number 427246-001●

For tips on routing and labeling fiber-optic cables, refer to the

Compaq NonStop Himalaya Cluster Switch Hardware Installation

and Support Guide (PN 426921-001).

Problem: Table D-1 on page D-2 categorizes the uninterruptible

power supply (UPS) as a Class 3 customer-replaceable unit (CRU).

Correction: The UPS is a field-replaceable unit (FRU). As a FRU it

can be replaced in the field only by qualified personnel trained by

Compaq and cannot be replaced by customers. Service providers

should refer to the instructions in the Himalaya S-Series Service

Provider Supplement.

Problem: Page 5-3 of the ServerNet Cluster Manual does not contain

a procedure for moving ServerNet cables to different ports on the

ServerNet II Switches. A reference to this procedure points to another

manual, which also does not contain the procedure.

Correction: A procedure for moving ServerNet cables to different