ServerNet Cluster Web

The G06.21 RVU supports the HP NonStop ServerNet Switch (model 6780) and
the layered topology for ServerNet clusters. For more information, see the ServerNet
Cluster 6780 Planning and Installation Guide and the ServerNet Cluster 6780
Operations Guide.
December 16, 2002
Known Documentation Problems has been replaced by two separate topics:
Known Problems With Manuals and Known Problems With Online Help. Each of these
topics is organized by the version of manual or online help system. You can check
only the problems that pertain to the version of the documentation you are using.
May 28, 2002
Known problems with Documentation. Added the following correction:
In Section 4, "Upgrading a ServerNet Cluster," the "Steps for Merging Two
Star Topologies to Create a Split-Star Topology" include sub-steps for
aborting all Expand-over-ServerNet lines and stopping the ServerNet
cluster subsystem ($ZZSCL) before running the guided procedure for
adding a cluster switch (Add Switch). However, the guided procedure will
not run if the $ZZSCL subsystem is stopped. An error message (Error
1002: Cluster Software Not Ready) is returned.
❍
●
FAQ addition: What are the requirements for using 5-kilometer cable for the
switch-to-switch links in the split-star and tri-star topologies?
●
February 6, 2002
Known problems with Documentation. Added the following correction:
The version number of the online help file included in the TSM 2001D client
software is incorrect. The help file (FABRICTS.CHM) included with the
TSM 2001D client software shows the help version as Version 2.0. The
correct online help version for TSM 2001D should be Version 3.0 or later.
❍
●
November 29, 2001
Starting with G06.14, ServerNet Cluster has increased support from 16 to
24 servers. These servers can be connected in a group, or ServerNet cluster.
●
Known problems with Documentation. Added the following
corrections:
In the "Upgrading a Split-Star Topology to a Tri-Star Topology" topic, Step
1 directs the user to merge two split-star topologies, which is not supported.
Step 1 should direct the user to merge a split-star topology with a star
topology.
❍
●