ServerNet Cluster Web

ServerNet Cluster Manual (520575-001)
Problem: In Section 4, "Upgrading a ServerNet Cluster," the "Steps
for Merging Two Star Topologies to Create a Split-Star Topology"
include sub-steps for aborting all Expand-over-ServerNet lines and
stopping the ServerNet cluster subsystem ($ZZSCL) before running
the guided procedure for adding a cluster switch (Add Switch).
However, the guided procedure will not run if the $ZZSCL subsystem
is stopped. An error message (Error 1002: Cluster Software Not
Ready) is returned.
Workaround: Do not stop the ServerNet cluster subsystem
($ZZSCL) before running the guided procedure for adding a
cluster switch (Add Switch).
Problem: The height of the cluster switch enclosure is listed as 37.6
in. (95.5 cm) in the Switch Enclosure Dimensions table in Section 2,
"Planning for Installation." The correct height of the switch enclosure
is 20.5 in. (52 cm).
Correction: The correct height of the cluster switch enclosure
appears in the G06.16 version of the ServerNet Cluster Manual
(520575-002).
Back to Top of Page
ServerNet Cluster Manual (520575-002)
Problem: Page 8-13 does not include a cause code that appears
when $ZZSCL abends because of a duplicate node number. Cause
codes appear in the Cause column of the SCF STATUS SUBNET
display.
Correction: The list of cause codes on page 8-14 should include
DPSN (Duplicate System Number)
Back to Top of Page
ServerNet Cluster 6780 Operations Guide (525606-002)
Problem: Page 4-17 does not include a cause code that appears
when $ZZSCL abends because of a duplicate node number. Cause
codes appear in the Cause column of the SCF STATUS SUBNET
display.
Correction: The list of cause codes on page 4-17 should include
DPSN (Duplicate System Number)