Replacing a TRSA CRU

Stopping the Communications Lines That Use
a TRSA CRU
To stop a SNAX/TR line:
Refer to the SNAX/XF and SNAX/APN Configuration and Management Manual.
To stop an IPXPROTO process:
1 Stop the IPXPROTO process:
Use the SCF STOP PROCESS command:
STOP PROCESS $<process-name>
2 Verify that the IPXPROTO process is in the STOPPED state.
Use the SCF STATUS PROCESS command:
STATUS PROCESS $<process-name>
The example shows the output of this command.
To stop a Port Access Method (PAM) line:
1 Stop the PAM line:
Use the SCF STOP LINE command:
STOP LINE $<line-name>, SUB ALL
2 Verify that the PAM line is in the STOPPED state.
Use the SCF STATUS LINE command:
STATUS LINE $<line-name>
The example shows the output of this command.
To stop a TCP/IP subnet:
Caution: Make sure that the TACL session from which you are issuing SCF
commands is not running on the subnet that you are about to stop.