Replacing a TRSA CRU

5 Start the logical interface (LIF).
Use the SCF START LIF command:
START LIF $ZZLAN.<lif-name>
6 Verify that the LIF is in the STARTED state.
Use the SCF STATUS LIF command:
STATUS LIF $ZZLAN.<lif-name>
The example shows the output of the SCF STATUS LIF command.
If the SCF STATUS ADAPTER command shows that the TRSA CRU SAC object is still
in the STARTING state after a few minutes or if the OSM Service Connection or the
TSM Service Application indicates that the resource needs attention, do the following:
1 Check for event messages in the Event Message Service (EMS) log. See
"Finding SLSA Subsystem Event Messages in the Event Log" in
Troubleshooting the SLSA Subsystem for more information.
2 Check the firmware version of the new TRSA CRU. See "Updating the
Firmware on a SLSA Adapter" in Troubleshooting the SLSA Subsystem for
more information.