Replacing an ATM3SA CRU

Standard Operating Practices
Caution. Replace only one CRU or FRU at a time. Attempting to replace more
than one hardware component at a time might cause serious system outages,
processor halts, and connectivity problems.
Whenever you replace a CRU or a FRU, use the following standard operating practices
to minimize any potential damage to the equipment:
Complete HP training courses on system support for NonStop S-series servers.●
Inspect the replacement CRU or FRU for any physical damage before installing
it. Check the connectors on the CRU, FRU, or backplane for bent or broken pins
and for any other obvious damage. If there is damage to the CRU or FRU, you
need to order another one.
●
Remove all jewelry and metal accessories, such as rings, watches, and
necklaces, before working with the equipment. These items can damage
electrical equipment or result in personal injury.
●
Restrain any dangling items that can get caught in electromechanical equipment,
such as long hair and sleeves, before working with the equipment.
●
Follow the ESD Guidelines for working in an electrostatic discharge
(ESD)-protected environment and for handling CRUs and FRUs.
●
Avoid permanent damage to components from overheating by observing the time
limits for an enclosure door to be open with only one fan running.
●
The following table indicates the amount of time that components in a fully
loaded NonStop S-series system enclosure, with the appearance-side door
open and only one fan operating, can operate before overheating.
Safe Operating Times With Enclosure Door Open
Ambient Room Temperature
Altitude 25°C (77°F) 30°C (86°F) 35°C (95°F) 38°C (100°F)
Sea level >45 minutes 36 minutes 21 minutes 13 minutes
1,524 meters
(5,000 feet)
38 minutes 22 minutes 13 minutes 8 minutes
3,048 meters
(10,000 feet)
25 minutes 14 minutes 10 minutes 5 minutes