Replacing an ATM3SA CRU

Verifying That the Communications Lines That
Use an ATM3SA CRU Are Started
1 Verify that the TCP/IP subnets are started.
Use the SCF STATUS SUBNET command:
STATUS SUBNET
$<tcpip-process-name>.#<subnet-name>
The example shows the output of this command.
2 Verify that the WAN subsystem input/output processes (IOPs) are started.
Use the SCF STATUS DEVICE command:
STATUS DEVICE $ZZWAN.#<device-name>
The example shows the output of this command.
3 Verify that the lines are started.
Use the SCF STATUS LINE command for a single line:
STATUS LINE $<line-name>
Use the SCF STATUS PATH command for an Expand multiline path:
STATUS PATH $<path-name>
The example shows the output of these commands.
4 If a SUBNET, DEVICE, LINE, or PATH object is not in the STARTED state,
check the event log by using the OSM or TSM Event Viewer. See the
Operator Messages Manual for event message cause, effect, and recovery
information.