Replacing an E4SA CRU

4 Verify that the physical interfaces (PIFs) are in the STARTED state.

Use the SCF STATUS PIF command:

STATUS PIF $ZZLAN.<adapter-name>.*

The example shows the output of the SCF STATUS PIF command.

5 Start the logical interfaces (LIFs).

Use the SCF START LIF command for each LIF:

START LIF $ZZLAN.<lif-name>

6 Verify that the LIFs are in the STARTED state.

Use the SCF STATUS LIF command:

STATUS LIF $ZZLAN.*

The example shows the output of the SCF STATUS LIF command.

If the SCF STATUS ADAPTER command shows that the E4SA CRU SAC object is still

in the STARTING state after a few minutes or if OSM or TSM indicates that the

resource needs attention, do the following:

1 Check for messages in the event log by using the OSM or TSM Event

Viewer. See Finding SLSA Subsystem Event Messages in the Event Log

for more information.

2 Check the firmware version of the new E4SA CRU. See Updating the

Firmware on a SLSA Adapter for more information.