Replacing an Internal Disk Drive CRU

Change History for Replacing an Internal
Nonmirrored Disk Drive CRU
September 6, 2005
Updated topic references with their NTL location.
September 24, 2003
Updated TSM references to include OSM.
June 2, 2003
Changed references from the obsolete NonStop S-Series Hardware
Support Guide to references to CSSI topics.
March 19, 2001
Corrected the command for creating a new label for a disk volume.●
Added a note stating that you must use the NEWFORMAT option
with the DSAP VOLUME, SQL command for disk drives larger than
18 GB.
●
March 9, 2001
Included both TSM actions and SCF commands when available.●
Included other sources of information.●
Included a note about upgrading to larger capacity disks.●
Added step for labeling the replacement disk drive.●
October 6, 1998
The instruction page for Installing an Internal Disk Drive CRU has
been modified as follows:
●
The statement about checking for damaged pins has changed.
There are two connectors located on the rear of an internal disk
drive. The large data connector does not have pins. The
smaller, square 24-pin power connector has pins that need to
be checked.