Replacing and Installing Enclosure Doors and Side Panels

3 Position the adapter frame on the enclosure:
a. Position the adapter frame on the outside of the cable channel frame.
b. Align the mounting hooks on the adapter frame with the enlarged
holes near the top of the cable channel frame.
c. Push the adapter frame in and down so that the mounting hooks
engage and support the adapter frame.
d. Verify that the adapter frame is flush against the cable channel frame
and that the screw holes are aligned.
4 Install 4 M5 Phillips screws and 4 M5 KEP nuts on the adapter frame:
See Installing a Screw and KEP Nut on an Adapter Frame and Securing an
Adapter Frame to an Enclosure.
a. Insert a Phillips screwdriver through an access hole in the adapter
frame.
b. Use the screwdriver to insert a Phillips screw in the hole.
c. Hold the screw in position using the screwdriver, and from the inside
of the cable channel, install a KEP nut on the end of the screw.
d. Hold the KEP nut, tighten the screw, and then back it off 1/4 turn.
e. Install the remaining KEP nuts in the same way, and then fully tighten
the screws.
5 Return to Step 2 of Removing and Installing Enclosure Doors.