Replacing or Installing MSEB Plug-In Cards (PICs)
Table Of Contents
- Replacing or Installing MSEB Plug-In Cards (PICs)
- Replacing or Installing MSEB Plug-In Cards (PICs)
- MSEB Faceplate and Ports
- MSEB PIC Locations
- MSEB PICs, Filler Panel, and Mounting Hardware
- ESD Guidelines
- Fig: Working in an ESD Protected Environment
- Standard Operating Practices
- Unlocking and Opening a System Enclosure Door
- MSEB Cover Panel
- PIC Mounting Hardware
- Filler Panel Mounting Screws
4 Secure the PIC to the MSEB.
Using a #10 Torx screwdriver, install a 20mm T-10 Torx screw to
secure the front corner of the PIC and tighten the screw.
●
Using your fingers, install the plastic nut on the threaded stud at the
center rear of the PIC. Tighten the nut until it is finger tight.
●
5 From the rear of the MSEB, slide the cover panel into place. Install the
seven T-8 Torx screws that secure the cover panel to the MSEB.
Installing an MSEB in an Enclosure
6 Continue with the OSM action or guided procedure to install the MSEB.
7 Close and lock the appearance-side enclosure door.