Upgrading to S76000 and S86000 PMF CRUs

The appropriate OSM action or guided procedure for replacing PMF CRUs. See

Guided Procedures for more information.

●

You must perform these steps in exactly the order listed here, even if you have

successfully performed previous upgrades by doing these steps in a different order.

1 Install the G06.16 SUT. For further instructions, see the G06.16 Software

Installation and Upgrade Guide (or a later version). For those migrating from

pre-G06.16 release version updates (RVUs), the guide also describes a step

needed after the SUT is installed.

2 Update service processor firmware.

3 Update processor boot code.

4 Run the ZPHIRNM program.

5 Load the G06.16 RVU.

6 Update the SCSI boot code and perform post-load steps as needed.

7 Use the OSM Service Connection or the TSM Service Application to check

for alarms and verify that the system is operating properly. Resolve any

problems before you install new hardware.

8 Replace one PMF CRU by using the OSM action or guided replacement

procedure.

When the procedure prompts you to physically replace the PMF CRU, a help

button appears that allows you to access detailed instructions.

Caution: Verify the Gemini daughter boards are fully seated before

installing the PMF CRUs. See Tech Bulletin TB20051B.

9 Verify that the PMF CRU is operational, and then immediately replace the

other PMF CRU in the same enclosure by using another OSM action or

guided replacement session.