Enclosures Missing in OSM or TSM Management Windows

Enclosures Missing in OSM or TSM

Management Window

Symptom

After a System Discovery, some enclosures are not displayed.

Version

All.

Problem

You have inserted, replaced, or moved a PMF CRU or IOMF CRU

configured for a topology that does not match the topology of this system.

This problem can also occur in a system configured as a Tetra 16 topology

if a PMF CRU or IOMF CRU has been moved from the outer tetrahedron to

the inner tetrahedron.

Group numbers for inner and outer tetrahedrons are listed here.

Inner Tetrahedron

Processor

Enclosure

I/O Enclosure

01 11 12 13 14 15

02 21 22 23 24 25

03 31 32 33 34 35

04 41 42 43 44 45

Outer Tetrahedron

Processor

Enclosure

I/O Enclosure

05 51 52 53 54 55 56 57 58 59

06 61 62 63 64 65 66 67 68 69

07 71 72 73 74 75 76 77 78 79

08 81 82 83 84 85 86 87 88 89

PAGE 1
Enclosures Missing in OSM or TSM Management Window Symptom After a System Discovery, some enclosures are not displayed. Version All. Problem You have inserted, replaced, or moved a PMF CRU or IOMF CRU configured for a topology that does not match the topology of this system. This problem can also occur in a system configured as a Tetra 16 topology if a PMF CRU or IOMF CRU has been moved from the outer tetrahedron to the inner tetrahedron. Group numbers for inner and outer tetrahedrons are listed here.
PAGE 2
Fix 1 Verify that the affected enclosure is powered on. 2 Using the OSM or TSM Low-Level Link Application, check the Topology attribute of all PMF CRUs and IOMF CRUs in your system. Begin with the one that was most recently inserted. System discovery is required. 3 If the Topology attribute of any PMF CRU or IOMF CRU does not match the topology of your system, reset the topology of your system using one of the OSM or TSM Low-Level Link Application Set Topology actions.