Troubleshooting the SWAN Concentrator and WAN Subsystem

Find the Name of the SWAN Concentrator Used by a WAN Subsystem IOP OR Find
the Names of the WAN Subsystem IOPs Configured to Use a SWAN Concentrator
To determine name of the SWAN concentrator used by a specific WAN subsystem IOP,
use the SCF INFO DEVICE command:
INFO DEVICE $ZZWAN.#<device-name>
The example shows the output of this command and explains how to interpret it.
To determine the names the WAN subsystem IOPs configured to use a specific SWAN
concentrator, use the SCF STATUS ADAPTER command:
STATUS ADAPTER $ZZWAN.#<adapter-name>, SUB ALL
The example shows the output of this command and explains how to interpret it.
Back to the figure
Find the TCP/IP Processes and IP Addresses That Support a SWAN Concentrator
To determine the TCP/IP processes and the IP addresses that support a SWAN
concentrator, use the SCF INFO ADAPTER command:
INFO ADAPTER $ZZWAN.#<adapter-name>
The example shows the output of this command and explains how to interpret it.
To find the processors where the primary and backup TCP/IP processes are running, use
the SCF STATUS PROCESS command:
STATUS PROCESS $<tcpip-process>
The example shows the output of this command and explains how to interpret it.
Back to the figure
Find the LIFs Associated With the TCP/IP Processes and IP Addresses That Support
a SWAN Concentrator
To determine the LIFs associated with the TCP/IP processes and IP addresses that support
the SWAN concentrator, use the SCF INFO SUBNET command for the preferred and
alternate TCP/IP processes:
INFO SUBNET $<pref-tcpip-process>.*
INFO SUBNET $<alt-tcpip-process>.*
Scan each SCF INFO SUBNET display for the preferred and alternate IP addresses for the
SWAN concentrator. The LIF name associated with an IP address is shown in the
Devicename column of the SCF INFO SUBNET display. The example shows the output of