HP Fabric Clustering System Release Notes, September 2004

HP Fabric Clustering System
Compatibility Information and Installation Requirements
Chapter
5
• HP Fabric Clustering System version B.11.23.02 is only supported with the following:
— HP-UX 11i v2 operating system
— AB286A HP PCI-X 2-port 4X Fabric (HPC) Adapter
— AB291A HP 12-port 4X Fabric Copper Switch
— AB399A HP 24-port 4x Fabric Copper Switch
— The AB346A, AB353A, AB347A HP 4x Fabric Copper Cables
Supported Features
• On-Line Addition and Replacement (OLAR) of HP Fabric Clustering System adapters is now supported
on HP Fabric Clustering System version B.11.23.02.
NOTE A critical data error resulting from the presence of IPoIB interfaces on the HCA will cause
the suspend operation to fail. For more details on successfully suspending an HP Fabric
Clustering System HCA, see “Suspending an HP Fabric Clustering System HCA Using the
olrad (1M) Command” on page 8.
• IPoIB has been enhanced to support 64-bit MIB counters (RFC 2863).
Compatibility Information and Installation Requirements
The information in this section lists the requirements needed to install and run the HP Fabric Clustering
System, including the following:
Hardware Requirements
Supported HP Integrity Server Platforms:
Table 1 HP Integrity Platform Compatibility
Platform Max HCAs
rx26xx 2
rx1600 2
rx56xx 2
rx4640 2
rx7620 8
rx8620 8
Superdome 8