HP Integrity rx1600 Operation and Maintenance Guide

Chapter 7
Removing and Replacing Components
Removing and Replacing System Memory
136
Step 2. Close the cover by moving the latch handle clockwise.
Figure 7-4Closing the Cover
Removing and Replacing System Memory
System memory DIMMs are located on the system board.
WARNING Ensure that the system is powered-down and all power sources have been disconnected from the server
prior to removing or replacing system memory.
Voltages are present at various locations within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions could result in damage to the server.
CLOSED
OPEN